Palo Alto VM Series HA Deployment on OCI

🔥 Implementing Palo Alto VM series firewall in HA mode on OCI.

🏢 Creating the architecture on OCI, including separate subnets for different interfaces.

👨‍💻 Step-by-step implementation of the firewall on OCI console.

🏢 Create subnets for trust, HA, public, and management interfaces.

🌐 Create internet gateway and route table for public subnets.

💻 Provision Palo Alto VMs in the management subnet.

🔑 Creating and configuring VNICs for Palo Alto VM Series on OCI

🌐 Assigning secondary IP addresses for untrust and trust interfaces

🔒 Setting the admin password for Palo Alto VM instances

🔑 Configure interfaces and assign IP addresses for Palo Alto VM Series in HA deployment on OCI.

⚙️ Set the MTU size to 9000 for Jumbo frames on the interfaces.

🔑 Setting up Palo Alto VM Series in high availability.

🔒 Configuring control links and data links for HA.

✅ Committing the configuration for successful setup.

🔥 The HA configuration on both Palo Alto VM firewalls has been completed successfully.

🔄 The synchronization of the devices has been achieved, indicating a successful configuration of HA.

🌐 To enable the movement of the floating IP between VM instances, Dynamic Groups and IM Policies need to be created in OCI.

📝 Creating a management profile to allow traffic termination in the interface

🚀 Configuring a route and adding an interface to a security zone

🔁 Testing the high availability of Palo Alto VM Series on OCI