Understanding Pump Selection and Efficiency
This video discusses pump selection based on flow rate and head specifications, with an example of finding the operating point and horsepower required.
00:00:00 This video discusses the process of pump selection based on operating conditions and provides recommendations for finding the right pump.
🔍 To find a suitable pump, we need to consider the required flow rate and head rise.
🌊 There are two options for pump selection: Grundfos and Taco.
💡 The desired flow rate is 0.1 cubic meters per second, equivalent to 1585 US gallons per minute. The head rise is 80.27 meters or 263 feet.
00:01:33 A variety of pumps with different specifications are presented for selection. One model requires a 130 horsepower motor, operates at 1760 rpm, and has an 80% efficiency. Another model has a 9 NPSH requirement and a 6-inch discharge.
🔍 The video discusses the process of selecting pumps for specific applications.
💡 The pumps mentioned in the video have varying power requirements, impeller diameter, efficiency, and suction/discharge line sizes.
📏 The video points out the importance of properly sizing piping for the selected pumps.
00:03:06 In a video titled 'Pump Selection', the speaker discusses the efficiency of different pumps based on their operating points on a graph. The speaker identifies a pump with high efficiency and recommends further investigation.
📈 The efficiency of the pumps decreases as we move down the list.
🗺️ Operating points that are further down the list are outside the intended range.
🔍 The KS 80 16 pump is the most efficient and a potential good choice.
00:04:41 This video explains pump selection based on the head flow curve. It demonstrates how different flow rates affect the pump's output head and provides insight into operating points and impeller sizes.
💡 The head flow curve shows the pump's output head at different flow rates.
🔴 The red point indicates the suggested operating point for the pump.
🔄 Different impeller sizes can affect the flow rate and head of the pump.
00:06:14 Choosing the right pump size is crucial for achieving the desired flow rate. A larger impeller is needed to achieve the necessary head for driving the flow at a rate of 100 liters per second.
📊 Based on the design flow rate, a 16.5-inch pump would result in an output head of approximately 280 feet.
⬇️ Using a smaller impeller, such as a 15-inch or 14-inch, would decrease the output head to around 235 feet and under 200 feet respectively.
🔍 To achieve the desired flow rate, a larger impeller should be chosen, possibly by milling down a 16.5-inch impeller to a slightly smaller diameter.
00:07:45 A summary of the video on pump selection explaining the relationship between head, power, and efficiency and the benefits of operating at the maximum efficiency point.
💡 The graph represents the relationship between power, head, and flow rate in pump selection.
⚡ Operating below maximum efficiency, the pump requires a specific amount of power to drive the desired flow.
📈 By optimizing the operating point, higher efficiency levels of up to 84% can be achieved.
00:09:19 This video discusses pump selection based on flow rate and head specifications, with an example of finding the operating point and horsepower required.
📊 The required ND SH for the pump is around 15 feet based on the design flow rate.
💡 The specifications recommend an NPS H of 16 feet, which is close to the calculated value.
⚙️ The operating point of the pump requires a horsepower between 125 and 150 with 80% efficiency.
Want to deep dive into this video?
